i was commissioned by a member to make him a leather edc case for his swiss army knife, a led lenser p3, and a usb data carry device, he wanted a way to carry these items in the small of his back be discrete, and to be black with black stitching he also wanted the bottom closed, so what i have done, as i have with some of my other commissions, i put a retention wall in there so you get the best of both worlds, you are able to shed water if needed, and there is no way of the item coming out, also as he wasnted these items off set, and for the torch to be inserted bezel up, and the on off button is at the other end, and if completely enclosed would turn the torch on if totally enclosed, this eradicated this problem, perfectly.
hope you like it.
IMG_4136 by lucky_lee, on
IMG_4139 by lucky_lee, on
IMG_4141 by lucky_lee, on
IMG_4143 by lucky_lee, on Flickr
all comments are welcome.
thanks for looking.
take care.
lee.
hope you like it.
IMG_4136 by lucky_lee, on
IMG_4139 by lucky_lee, on
IMG_4141 by lucky_lee, on
IMG_4143 by lucky_lee, on Flickr
all comments are welcome.
thanks for looking.
take care.
lee.