Part 1
Hope to have this finished by next week, I'll just post photos as I go.
First job, sanding down a piece of unfinished american white ash, from the timber yard.
The sheet of PE1000 is TIVAR, and 15.78" wide, 9.8 feet long.
Measure the sled blank, and cut it out, making it 'coffin shaped' or tapering at either end.
Front end, 2" in from either side, 2 feet along the length.
Back End, 1" either side, then 2 fet down the length.
Cut with a jigsaw, and finish with a handheld plane.
Hope to have this finished by next week, I'll just post photos as I go.
First job, sanding down a piece of unfinished american white ash, from the timber yard.
The sheet of PE1000 is TIVAR, and 15.78" wide, 9.8 feet long.
Measure the sled blank, and cut it out, making it 'coffin shaped' or tapering at either end.
Front end, 2" in from either side, 2 feet along the length.
Back End, 1" either side, then 2 fet down the length.
Cut with a jigsaw, and finish with a handheld plane.
Last edited: