montana hunter
the blade blank was purchased from Jantz Supplies in the US, it's made from AUS6 stainless steel hollow ground with a false edge and thumb notch on the spine, it has been cryo heat treated to give a tough edge of Rc 57 and satin finished.
Blade length 95mm
width 24mm
thickness 3mm
handle is 116mm long with oak dymond wood scales held in place with devcon 2 ton epoxy and 4x 4mm brass pins.
A sheaths of 2.5mm veg tanned shoulder will be supplied with each knife
I'm asking £40 inc postage
you must be over 18 to buy this Item
the blade blank was purchased from Jantz Supplies in the US, it's made from AUS6 stainless steel hollow ground with a false edge and thumb notch on the spine, it has been cryo heat treated to give a tough edge of Rc 57 and satin finished.
Blade length 95mm
width 24mm
thickness 3mm
handle is 116mm long with oak dymond wood scales held in place with devcon 2 ton epoxy and 4x 4mm brass pins.
A sheaths of 2.5mm veg tanned shoulder will be supplied with each knife
I'm asking £40 inc postage
you must be over 18 to buy this Item