
The black thin leather was peeling a bit and appeared fragile, and i wanted to change it..., i peeled it off, i took photos, and tried to use reuse parts as templates..

the wooden sheath had drawings on it.... The wood seemed to be pine, possibly from a packing case or pallet

I made a new set of holders for the small knives and accessories, this also folded over the top of the sheath...

I carved a new piece of wood to cover the holders, based on the shape of the original that was too small..

No pictures of soaking the leather, but i roughly sized it using the original, i soaked it in warm water and stretched it over the wood sheath, moulding it till the leather was drying out. I stitched it in place and trimmed it once dry. I used some clamps to help hold unstitched pieces together...

Once dried out, i checked the fit of the blades, then eventually i warmed it up and covered it with beeswax..

i made a belt loop to fit over the sheath from some thicker leather...
