Decided to move onto another project so going to hand this batton on. Its still a work in progress needing some of the dinks removing, blade polishing and a hair poping sharpen.
As a work knife it probably doesn't need any more time spent on it but i should point out there is a bit of a gap - less than a fingernail thick between the scales and the backspring - again doesn't effect opening or the solid feel the knife has when open - dont even think it can bee seen in the picture but i feel i should point it out.
Carbon steel blade has been re duced to 3" OAL for extra EDCability
Alsoup for grabs is a lightly used yet clean opinel no 12 folding saw, its had a tidy and some oil
Trades wise I'm after
a non locking sub 3" blades two layer Vic sak with a saw and plastic scales
a brass trench lighter
Martac AAA copper torch (for both items)
swedish gasmask bag - brown leather bottomed version must be grade 1 or better
As a work knife it probably doesn't need any more time spent on it but i should point out there is a bit of a gap - less than a fingernail thick between the scales and the backspring - again doesn't effect opening or the solid feel the knife has when open - dont even think it can bee seen in the picture but i feel i should point it out.
Carbon steel blade has been re duced to 3" OAL for extra EDCability
Alsoup for grabs is a lightly used yet clean opinel no 12 folding saw, its had a tidy and some oil
Trades wise I'm after
a non locking sub 3" blades two layer Vic sak with a saw and plastic scales
a brass trench lighter
Martac AAA copper torch (for both items)
swedish gasmask bag - brown leather bottomed version must be grade 1 or better
Last edited:
