Granny B

[fredcraft]

Very nice!
How on earth did you rescue the logo?

Yea, that's pretty much what is puzzeling me at the moment too ! That and I am also wondering about any replacement (blades, screwdriver, etc...) that Victorinox could do over the years, do they accept re-handled SAKs ? And if so, would you trust them to do the job ?

All in all, it's indeed a great looking knife :You_Rock_ (kudos to Bob). It's sentimental value just went through the roof !

 

[The Joker]

Sean, that really is a superb piece of workmanship.

You can tell by looking at it that there's a person who enjoys their craft.

Leon, you must be very proud of it (neally as much as Sean is probably)

 

[bushwacker bob]

Very nice!
How on earth did you rescue the logo?

Some SAKs have an inlaid steel logo,some are printed with silver paint.This was one of the steel ones,there is a moulding hole on the back of the plastic scale and you can gently push a pin through and pop the badge off the front.On this one, it was remounted embedded in clear epoxy resin.