Anyone fancy making a traditional English shaving horse?

[demographic]

You know, like the ones that Bodgers used to use for making chairs and so on?Cos I spotted these PDF plans on the Veritas tools site.

I have no connection to Veritas blah blah blah, usual disclaimer....but if Veritas really do feel the need to send a low angle adjustable mouth block plane to me for this I can be contacted via PM

 

[weaver]

I made mine similar to that but didn't think of using the seat for a work bench. Thanks for the link, I will incorporate some of the ideas into my horse.

 

[Buckshot]

That's quite a complicated one - lots of good uses though.
There's a more simple one on the woodturners website here It's after the pole lathe designs.
Also has a pdf version I think

It's on the list for me to do at some point...

Mark

 

[demographic]

That's quite a complicated one - lots of good uses though.
There's a more simple one on the woodturners website here It's after the pole lathe designs.
Also has a pdf version I think

It's on the list for me to do at some point...

Mark

Thats a good PDF also, I doubt I would ever make one but its interesting all the same.

 

[weaver]

Yeah, That's more like the one I made. Wish I had seen that, would have saved me some calculation.