Green River blades

[davek]

Made some slabs for my Green River blades. They are machined hard anodized aluminum. They look great (bad pics), but might be cold and slick outdoors.

I put a layer of epoxy between the slabs and the full tang in the hopes of preventing a reaction between the metals. Comments on whether that will work? What is that reaction again?

 

[forestwalker]

Nice work (even if not my style). I presume you were talking about galvanic corrosion.

Where did you get the blades?

 

[davek]

Nice work (even if not my style). I presume you were talking about galvanic corrosion.

Where did you get the blades?

Ya that thanks.

I got them at Smoky Mountain Knife Works (Tennessee, U.S.).
Huge, fantastic knife store, the blades were 10$ each and I picked ones with straight lines to make them easy to "mass produce".
The engraving will vary.

Not in this for profit, will be gifts or sold for cost.