HI
decided to try and make a lid out of aluminium sheet same as others have made on bushcraft
Not made one before and tried it by tapping out on the mug
left about a 1" oversize to allow for the bending
The only problem I had was that I think there was to much of a oversise as I was getting large folds in the edge as it was folding so had to remove about 3/4" the rest folded over much easier
I then used a large offcut of round bar on the inside of the fold to tap the edge against it
I have to fit a handle and am thinking of a cut out like on the plastic lid for pouring
http://s137.photobucket.com/albums/q209/MWGurmin/?action=view¤t=imag0006-1.jpg
Mick
decided to try and make a lid out of aluminium sheet same as others have made on bushcraft
Not made one before and tried it by tapping out on the mug
left about a 1" oversize to allow for the bending
The only problem I had was that I think there was to much of a oversise as I was getting large folds in the edge as it was folding so had to remove about 3/4" the rest folded over much easier
I then used a large offcut of round bar on the inside of the fold to tap the edge against it
I have to fit a handle and am thinking of a cut out like on the plastic lid for pouring
http://s137.photobucket.com/albums/q209/MWGurmin/?action=view¤t=imag0006-1.jpg
Mick