Here's an idea (and it's probably not an original one)
Imagine a large but slim full tang bushy knife.
Now imagine we replace the tang with a woodsaw - like a small laplander - still with me?
Between the knife and the saw we have a pivot point and a couple of notches to catch on a couple of stop pins.
(imagine a svord peasant but both ends are business ends)
Attached to the pivot point we have a handle which has a slot running right the way through to allow the blade or the saw to pass through.
The handle pivots 180 degrees underneath the saw and blade to switch between one and the other. Any pressure on the blade pushes against the stop pin in the handle.
Needs a bit of work, but I think I may be onto something?
Cheers
Mike
Imagine a large but slim full tang bushy knife.
Now imagine we replace the tang with a woodsaw - like a small laplander - still with me?
Between the knife and the saw we have a pivot point and a couple of notches to catch on a couple of stop pins.
(imagine a svord peasant but both ends are business ends)
Attached to the pivot point we have a handle which has a slot running right the way through to allow the blade or the saw to pass through.
The handle pivots 180 degrees underneath the saw and blade to switch between one and the other. Any pressure on the blade pushes against the stop pin in the handle.
Needs a bit of work, but I think I may be onto something?
Cheers
Mike
Last edited: