Advice sought re. located Optimus No.96 pressure leak

[Silverclaws2]

And so it has come to pass, perhaps as part of that midlife crisis that I have obtained the very variant of the Optimus No.96 that I used on my Queeen's Scout Expedition back in 1986 and in ' Fettlin ', I discover it has an air leak giving rise to inability to hold a burn of which hardly useful as I am not intending to retain this stove as a mere ornament.

To have by way of the submersion test found the air bleed screw on the filler cap isn't sealing of which is hardly drastic but I would be interested in receiving advice upon options before I plumb for a generic replacement.

Dunno, with experience of these stoves I get the sense that the bleed screw is an incorrect screw as it is overly long for it's purpose of which is not something I remember and of course the cone appears to be in seach of a deeper seating of which is not something my No.96 has

 

[Pattree]

There are certainly knowledgeable folk here who may be able to help you. (Not me I’m afraid - I have an aversion to moving parts.)

Otherwise may I recommend
Classic Camp Stoves where questions like yours are dealt with every day.

Edited to add:
They will be able to tell you, within microns, what you need and where to get it.

They are great people. I’ve dealt with them on line as a very ignorant rookie and they have helped me out. I’ve even met some of them at their camp.

 

[FerlasDave]

Have you tried wrapping some ptfe tape around the screw thread? It could be either worn thread or some dirt in the thread, I don’t believe there is a gasket that goes in there as far as I can remember but I’ll check one of my stoves later. Or possibly the clever use of a fibre washer? Hmmm

 

[JB101]

As above classic camp stoves is the place to visit.
Make sure that the threads are clean as a bit of debris could be enough to allow a leak.