I’ve been making whistles, flutes and pipes for many years. I mostly use plastic tubing or wood.
The windway works best if it narrows in both dimensions along the pipe so that the air is accelerated before it hits the blade.
Your whistle is a closed chamber and so technically a single note ocarina.
Well done!
Can you grind down a piece of solid antler to make a cylinder that fits the whistle’s diameter.
Now I’m estimating from your picture:
Then file/cut a diagonal flat on the cylinder running from a third of the back area to just shaving the circumference at the front end.
I make a little whistle that way.
If you make one open ended then you can play tunes by covering the end hole to different degrees with your hand.
Edited to add:
I don’t know how deep is the main chamber of your whistle but:
Maybe!
if you drilled a hole into the chamber at a point towards the bottom end, you could make a two note bosun’s whistle.
The windway works best if it narrows in both dimensions along the pipe so that the air is accelerated before it hits the blade.
Your whistle is a closed chamber and so technically a single note ocarina.
Well done!
Can you grind down a piece of solid antler to make a cylinder that fits the whistle’s diameter.
Now I’m estimating from your picture:
Then file/cut a diagonal flat on the cylinder running from a third of the back area to just shaving the circumference at the front end.
I make a little whistle that way.
If you make one open ended then you can play tunes by covering the end hole to different degrees with your hand.
Edited to add:
I don’t know how deep is the main chamber of your whistle but:
Maybe!
if you drilled a hole into the chamber at a point towards the bottom end, you could make a two note bosun’s whistle.
Last edited: