paracord bracelet troubles

[jonnywebb123]

Well i got my digital camouflage paracord bracelet kit in today after work
feeling good about it i started to make up the bracelet using a double cobra stitch, no problems till i got to the middle and relised it wasn't tight enough, so after some tightening i though i might as well started again so now the bracelet looks a tad squinty it seems that rather than going in a straight line its curving like a spiral stair case

any idea on what i am doing wrong here?

cheers jonny

 

[g4ghb]

not 100% sure but it sounds like you are not reversing each 'stitch' - this normally creates a straight knot rather than a spiral if that makes sense

 

[Melonfish]

just sounds like your tightening one side more then the other tbh i'd slacken it all off and start over, be sure to apply the same amount of pressure for each side of the knot.

 

[jonnywebb123]

i think it was a bot of both tbh, just re-done it there and i dont think i had fully stiched on both sides and as u said some bits were not as tight as others

all done now thanks guy


EDIT:

Here is a picture of the finished article, any though people?
http://www.facebook.com/photo.php?pid=192524&l=7fbd0ca392&id=100000210673702