I thought I'd give this a try.
3.5m of olive green pertex 4. Hemmed on two longer sides and a channel on each of the two shorter ends.
6mm Dyneema is currently being used but I have some 5mm on its way.
Cord was thread through each end cord and cinched up nice and tight, looped around and a square knot tied up nice and tight.
A short length of the same cord was attached to the hammock with a larks foot below 1st bit of cord.
Will it hold?
Although the wall posts of the new house are a little low, therefore the hammock is suspended much lower than I would normally have it.
It holds nicely!
It is super light weight. Just going out to take it down and weigh it.
3.5m of olive green pertex 4. Hemmed on two longer sides and a channel on each of the two shorter ends.
6mm Dyneema is currently being used but I have some 5mm on its way.
Cord was thread through each end cord and cinched up nice and tight, looped around and a square knot tied up nice and tight.
A short length of the same cord was attached to the hammock with a larks foot below 1st bit of cord.
Will it hold?
Although the wall posts of the new house are a little low, therefore the hammock is suspended much lower than I would normally have it.
It holds nicely!
It is super light weight. Just going out to take it down and weigh it.
Last edited: