hi....ok my third attempt, just needs a couple of touch-ups and final polish....once again i had trouble keeping glue off the blade at the handle leading edge....nightmare!....'Woodie' blade courtesy of HillBill...and very nice it is too, hope i've done it at least a bit of justice m8....laburnum, red liners, brass and copper loveless and copper lanyard....side on i'm not sure i like my choice because the coppers come out pinker than i expected....first time i've used it.....but when the darker red liners are in view too it seems ok, lemme know!
my three knives so far...two on left are Mammoth Blades Bushman in 4mm 01 carbon steel, buffalo horn, black and pewter liners with mosaic pins and brass lanyard...Mammoth Blades Huntsman in 4mm spring steel, bog oak, black and brass liners, 2 brass/nickel loveless bolts, one brass corby bolt and mosaic lanyard...on right is HillBill ''Woodie-clone'' in 3mm 01 carbon steel, laburnum, red liners, 2 copper/brass loveless bolts and copper lanyard.
my three knives so far...two on left are Mammoth Blades Bushman in 4mm 01 carbon steel, buffalo horn, black and pewter liners with mosaic pins and brass lanyard...Mammoth Blades Huntsman in 4mm spring steel, bog oak, black and brass liners, 2 brass/nickel loveless bolts, one brass corby bolt and mosaic lanyard...on right is HillBill ''Woodie-clone'' in 3mm 01 carbon steel, laburnum, red liners, 2 copper/brass loveless bolts and copper lanyard.
Last edited: