Hi Folks.
I was recently commissioned to make this knife. I've never made one like this before so it had some firsts in it for me.
Its basically a Bayley S4 with jimping, a curved rather than angled tang on the top and a protusion at the rear like on the Fallkniven F1.
It took me a while to make as that bolster fixing is tricky. Its like a stick tang bolster on a full tang knife. Took a few attempts before i got one i was happy with, but its not as perfect as i would like.
The steel is RWL-34 with black G10 handle and orange G10 liners, stainless tubes that i had to make myself from some 9mm stainless bar.
I was concentrating on getting all the bits right and realised after i had hardened it that i hadn't stamped it. Muppet...
I don't think it turned out too bad for a first try.
What do you guys think?
Cheers
Mark
I was recently commissioned to make this knife. I've never made one like this before so it had some firsts in it for me.
Its basically a Bayley S4 with jimping, a curved rather than angled tang on the top and a protusion at the rear like on the Fallkniven F1.
It took me a while to make as that bolster fixing is tricky. Its like a stick tang bolster on a full tang knife. Took a few attempts before i got one i was happy with, but its not as perfect as i would like.
The steel is RWL-34 with black G10 handle and orange G10 liners, stainless tubes that i had to make myself from some 9mm stainless bar.
I was concentrating on getting all the bits right and realised after i had hardened it that i hadn't stamped it. Muppet...
I don't think it turned out too bad for a first try.
What do you guys think?
Cheers
Mark