just got these back from heat treat, top four 3.5mm rwl34, bottom two 4mm n690
will be busy for a few days!
will be busy for a few days!
fresh out the oven!
- Thread starter mark.177
- Start date
-
BushMoot: Come along to the amazing Summer Moot 31st July - 5th August (extended Moot : 27th July - 8th August), a festival of bushcrafting and camping in a beautiful woodland PLEASE CLICK HERE for more information.
Are the bottom two roughly 3" blades?
If so, 4mm sounds quite thick for the geometry and I'll be very interested to see how they pan out.
They all look good but I esecially like the one labelled 60HRC.
If so, 4mm sounds quite thick for the geometry and I'll be very interested to see how they pan out.
They all look good but I esecially like the one labelled 60HRC.
Are the bottom two roughly 3" blades?
If so, 4mm sounds quite thick for the geometry and I'll be very interested to see how they pan out.
They all look good but I esecially like the one labelled 60HRC.
yes 3" blades. they were made using up some short off cuts of n690, being 4mm i gave them a full flat grind with some distal taper. ideally i'd have used thinner stock but would be a shame to waste it. hopefully they'll make good small game hunting knives?
Well let's see how they look when finished, eh? I kinda fancy that one.
What scales/liners/pins/finish are you thinking?
Hi Markjust got these back from heat treat, top four 3.5mm rwl34, bottom two 4mm n690
will be busy for a few days!
I presume your selling these?
PM me if you are.
Sent from my SM-G900F using Tapatalk
I'm not good with this tap a talk thing (or computers) how do I find that?
Sent from my SM-G900F using Tapatalk
Similar threads
