I am diy senseless. I want to put some screws up on my wall but I don't know how. The outer layer is thin plaster board, then a small airgap then breezeblocks. Drawing tacs just tear through. I borrowed my friends drill but there isn't the right tip to drill concrete.
They're not to bear any weight (it's for a twine wall mandala) so in looking for an alternate solution - could I maybe fill the holes with epoxy and that'd give a small screw enough purchase to stay put?
I did come up with an alternative solution to putting up a shelf - I used a couple of bushcrafty knots and some cord to hang the shelf off existing screw plugs on the wall.
They're not to bear any weight (it's for a twine wall mandala) so in looking for an alternate solution - could I maybe fill the holes with epoxy and that'd give a small screw enough purchase to stay put?
I did come up with an alternative solution to putting up a shelf - I used a couple of bushcrafty knots and some cord to hang the shelf off existing screw plugs on the wall.