Armed only with the file on a pocket multi-tool, some cheap wet-n-dry paper and an insane level of finger twiddling determination. The nuts for my DIY loveless bolts are almost done!!!
i used to make those for rob evs, but then, he sent me brass rod, i chopped it, faced it off and tapped to size. not for a while now. the stainless was a bear to tap, but i'm very glad it wasn't Ti!!
Not as bad as you'd think. Every time I had an odd five minutes waiting for somebody or something (kettle to boil, bus to come, swmbo, watching a movie etc) I'd get it out and do a little.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.