Dartmoor Knife.

[Madriverrob]

Thanks for the steer. Andy was most helpful but only has a couple of full sets available so still on the hunt. Does anyone have photos of the bolster or/and the measurements that they would be willing to share? I’ve found a contact with a full suite of machinery and may be able to persuade him to gin me one up!

Thanks in advance and I’ll let you know if it works out as once programmed it might be possible to get a few made!

PM sent

 

[Martin1966]

I got a mate to get a mate to make me one at work , mocked it up in plasticine ,with some measurements and then gave him the knife to final fit , cost me a pack of beers !

Many thanks! Paper and pencil at the ready and I’ll see how it goes! Very much appreciated!