Aldi Table Saw

[Trail Snail]

Apologies if this is in the wrong thread.

I bought one of these a few years ago, and since I've had it the blade has been a little off being straight. It is only slightly out and I have been able to use it for rough projects but I would like to calibrate it so that it cuts true.

Does anyone else have one of there (Workzone) and if so, do you know how to adjust the blade?

 

[Craig-SM]

Not familiar with the workzone table saw but most are usually adjustable from underneath with either a bolt or ramp to adjust fine tine the blade angle, then just use a square to ensure it’s at 90 degrees

the video below is for a DeWalt but a lot of the saws are similar for adjusting

If you’re getting the blade parallel then tighten each bolt up a little at a time or it will pull the blade out of alignment as you tighten them up.

 

[Trail Snail]

Cheers

I'll have a look for 2 bolts (or similar) on mine.

 

[Chainsaw]

I did a search for workzone table saw manual and found a manual on a website called manualslib. It may or may not be the same saw and it may or may not have good instructions on how to set it up but the manuals I have for other stuff was pretty good.

HTH
Alan