This is my 1st attempt (be gentle) making a full tang blade, Im not sure if the scandi grind is right but it is razor sharp.
I've been working on these blades for a couple days now and they are almost ready for HT.
They are 3mm thick Stock removal 01steel with some simple filework.
Overall length 165 mm and blade height of 25mm and its cutting edge is 65mm.
The 3rd one is one of Duncans dsk blade blank grinded by me with some simple filework.
And I grind the blades on this grinder
Any comments or criticism are welcome.
Thanks for looking!
Nektarios
I've been working on these blades for a couple days now and they are almost ready for HT.
They are 3mm thick Stock removal 01steel with some simple filework.
Overall length 165 mm and blade height of 25mm and its cutting edge is 65mm.
The 3rd one is one of Duncans dsk blade blank grinded by me with some simple filework.







And I grind the blades on this grinder



Any comments or criticism are welcome.
Thanks for looking!
Nektarios