1st attempt making a full tang blade.

[Nektarios]

This is my 1st attempt (be gentle) making a full tang blade, I’m not sure if the scandi grind is right but it is razor sharp.
I've been working on these blades for a couple days now and they are almost ready for HT.
They are 3mm thick Stock removal 01steel with some simple filework.
Overall length 165 mm and blade height of 25mm and its cutting edge is 65mm.

The 3rd one is one of Duncan’s dsk blade blank grinded by me with some simple filework.

And I grind the blades on this grinder

Any comments or criticism are welcome.
Thanks for looking!
Nektarios

 

[MSkiba]

I hope my first try comes out with similar results! Looks real good to me!

Are you going to heat treat it yourself or send off?

 

[Nektarios]

I hope my first try comes out with similar results! Looks real good to me!

Are you going to heat treat it yourself or send off?

Yes i will heat treat the blades my self.
And Thanks for the comment.

Cheers
Nektarios

 

[almac]

nice job!
i really like the one with the larger hole on the end of the handle.
just give it a good 550 paracord wrap, and yer done!

 

[Nektarios]

here is the FGYT/DSK blade, Still got to finish the handle.
handle material: box elder burl red vulcanfiber and Mosaic pins
end... hope you like it.

 

[Bluemerle]

That is a lovely looking little Knife.

 

[luckylee]

woww, those scales are breathtaking mate, i must get hold of some of that wood, stunning.

 

[Nektarios]

Thanks for the comments, Much appreciated!

Cheers
Nektarios