Search results

By letting private companies with no previous experience of nuclear power build them in remote locations such as the Welsh hills. Last Energy is an American company that is currently seeking a relaxation of safety regulations in the US...

I know exactly what you mean and assumed it was as common knowledge as coffee goes in the mouth rather than any other orifice.

"I can't hear you Keith." :)

https://www.bbc.co.uk/iplayer/episode/b00jzj72

Making a few more paracord bits, this one is on a very easy to lose knife.

Except that the buying and selling of counterfeits is illegal. ;)

Now you'll be needing one of the S-shaped triangular needles.

I do that too :) On pizza with tuna and onion. Tartare sauce is made with capers, parsley, chervil, gherkin, shallot and mayo. It’ll make fish and chips a lot better than the commercial stuff. As @Billy-o says, in melted butter for fish is good.

Don’t worry, I’ve already got his coat

Didn’t buy it today, but got an adaptor for the cheap butane canisters and fettled the pot supports a bit. This is a BRS-201A wok burner that cost £21.17 posted from Aliexpress. You’ll see why I need to run it on the £1 a pop cans ;)

Cascamite is good, get the surfaces freshly planed, glue and the usual 3 clamps and it should be fine.

That looks far from being a rot box.

Very easily. The beads come out ok, the particles want to sink so I set a layer of clear, then the glow, then more clear.

Don't start mate, you've a rep for being a pain. Have you read the OP? It's not a lesson in semantics, and it's not me asking the question. The question is, "I'm looking to upgrade my whittling knife and wondered if anyone has any suggestions."

Yeah, but he’s thinking of getting something nicer.

Fairly sure Kepis uses a slightly modified SAK for most stuff. The Little Book of Whittling intro recommends SAK also. I always fancied a nice Case Seehorse Whittler or a GEC (Tidioute and Northwoods) I had a tiny Brusletto Balder out the other day for a youngster to use and though the handle...

Sorry not to get back, away at the moment. Batteries first, the driver (board the LED is stuck to) is a 3A, so your 10A max draw battery, either the Fogstar or the Nitecore should be fine. I’ve been buying from Ecolux as they have such a massive choice of batteries and sizes. Fogstar seem to be...

Also worth knowing that the DBS is a great host for P60 drop-ins so you can upgrade your led module.

Hold fire for a bit and I'll find out. I don't want you actually holding fire as it were ;) My first thought is that an older light like this may not have a low voltage protection circuit and you may need a protected cell with the circuit in the battery. Over discharge of li-ion batteries isn't...

A fair few of us here did the same. I loved that programme.