My new crooked knife

[Captaincrash]

Had a go at a crooked knife blade today. I was pleased with the outcome so I made up a simple antler handle. I carved a slot out for the blade and epoxied it in place then secured it all with some hemp twine. the blade has a small bent section on the end of the tang that should keep it secured!!!

 

[Captaincrash]

Forgot to mention, the blade is made from an old carbon steel power hacksaw blade.

 

[mr dazzler]

Nice job. Have you any video of it being used yet?

 

[topknot]

I like how you made the blade from a power hacksaw blade , looks top's.

Topknot

 

[Hugo]

Looks good to me. I see you have the bevel on the inside, is this your preference to outside.
Must make one myself when I have time.

 

[bikebum1975]

Nice lookin knife. Gonna be on my project list this summer

 

[Captaincrash]

Looks good to me. I see you have the bevel on the inside, is this your preference to outside.
Must make one myself when I have time.

At this point I have no preference, this is my first crooked knife. Simple to make,I have less than an hour of my time into this one!

 

[Captaincrash]

Nice job. Have you any video of it being used yet?

No video as yet, I'm a little camera shy! I just made it yesterday and might get time on the weekend to try it out!

 

[gypsy slings]

that looks nice and traditnal mate weldone