Hello
I'm going to attempt fitting a handle to a blade, which has just arrived.
It's come with pre-drilled holes, 5 in total. One in the middle of approx 5mm, two at either end of 8mm, and then another two of 4mm.
Presumably using all 5, with a handle that will also be epoxied, is excessive? I had planned on 2 rivets or bolts.
Does that sound about right? I presume the range of hole sizes is to make it easier to source pins?
Lastly, are there any handy tutorials on the site?
Many thanks
I'm going to attempt fitting a handle to a blade, which has just arrived.
It's come with pre-drilled holes, 5 in total. One in the middle of approx 5mm, two at either end of 8mm, and then another two of 4mm.
Presumably using all 5, with a handle that will also be epoxied, is excessive? I had planned on 2 rivets or bolts.
Does that sound about right? I presume the range of hole sizes is to make it easier to source pins?
Lastly, are there any handy tutorials on the site?
Many thanks