Started off with a 4mm 1095 and 15n20 steel Damascus billet, and this knife design.
Total length 250mm, and 38mm at the widest point.
After a while I managed to get this out of it.
Next step is to grind out the profile and get the necessary holes drilled.
Tel me what you think.
Thanks for looking!
Total length 250mm, and 38mm at the widest point.
After a while I managed to get this out of it.
Next step is to grind out the profile and get the necessary holes drilled.
Tel me what you think.
Thanks for looking!
Last edited: