This blade was made by Rob Evans and finished and handled by myself. This is 5mm thick O1 steel heat treated to 58rc.
The bevels have been convexed and are finished with a slight micro bevel.
The handles are black canvas micarta held on with epoxy and also two brass & stainless loveless bolts and a brass lanyard tube. This handle is not going to shift!
The hook in the blade is for lifting your pot off the fire.
The hook won't be everyone's cup of tea so I'm prepared to reshape the blade to remove it, included in the cost. I don't think it will detract from the usability of the knife, if left in.
It's sheathless at this stage - it would have been daft to make one if it was going to be reshaped. I can make a leather one for it at extra cost but I'll leave it open so that you can make/commission your own.
Cost is £60 delivered in the UK.
The bevels have been convexed and are finished with a slight micro bevel.
The handles are black canvas micarta held on with epoxy and also two brass & stainless loveless bolts and a brass lanyard tube. This handle is not going to shift!
The hook in the blade is for lifting your pot off the fire.
The hook won't be everyone's cup of tea so I'm prepared to reshape the blade to remove it, included in the cost. I don't think it will detract from the usability of the knife, if left in.
It's sheathless at this stage - it would have been daft to make one if it was going to be reshaped. I can make a leather one for it at extra cost but I'll leave it open so that you can make/commission your own.
Cost is £60 delivered in the UK.
