Afternoon All,
I've got a couple of small stainless steel shackles and some brass pins from an old industrial socket.
The smaller pins are approximately 5mm diameter and the larger 1 was around 7. If used for knife pins with the terminals cut of the end usable length would be around 40mm each.
Shackles are not marked so not sure of their limit.
Not after a lot for them so try me.
Cheers
Jon
I've got a couple of small stainless steel shackles and some brass pins from an old industrial socket.
The smaller pins are approximately 5mm diameter and the larger 1 was around 7. If used for knife pins with the terminals cut of the end usable length would be around 40mm each.
Shackles are not marked so not sure of their limit.
Not after a lot for them so try me.
Cheers
Jon
