Hi dudes an easy way to hold stuff on your lap for carving. A Swedish lap vise as shown here by Dave Canterbury from about 3:50
Last edited by a moderator:
nice improvement I reckonKnocked this up this morning, 10" x 11.5" scrap of 12mm WBP ply, drilled, cut, sanded and given a couple of coats of Walnut oil. A little over an hour to make. It's a bit rough and ready but it works very well.
Nice, I like the ability to move the straps around as the workpiece dictates.Knocked this up this morning, 10" x 11.5" scrap of 12mm WBP ply, drilled, cut, sanded and given a couple of coats of Walnut oil. A little over an hour to make. It's a bit rough and ready but it works very well.
View attachment 38326 View attachment 38327 View attachment 38328