Hi
I have a couple of forged smiths knives going. One is a skinner type. Both are made from spring steel
the skinner has a hamon
Both £25
______________________________________________________________________
HI
I made and sold one of these recently so here is another.
Made from 3.4mm thick 1080 steel, scandi ground blade with Bocote with 6mm aluminum pins and lanyard hole 167mm total (just over 6.5inch) 3.5inch handle and very comfy to use its a nice little back up knife.
Same as this but diffrent wood and crappy photos :huh:
£45
_____________________________________________________________________
Here is a few stocking filers that wont break the bank
2 little keyring fobs, hand forged from floor brads with a 15mm split ring.
£5 each inc p+p
_____________________________________________________________________
Hi
been forging a bit recently and did some digging around and finished some blades I started a while back.
3 blades all done by me.
From the top down
a bowie blade (if thats what you call it) its a forged rustic looking thing but a real chopper. Made from 1095 spring steel with a deep edge quench. 285 mm long with a 170mm blade with a sabre grind. 33mm wide and about3.2mm wide.
Next up a Alabama damascus knife. 270mm long with a 141mm bade 24mm wide and 3mm thick. Saber ground. The tang will need reducing a little at the sides.
Last one is a forged kitchen knife blade, made from spring steel it is 216mm long with a 127mm blade, 30 mm wide and 3mm thick.
Bowie blade £37.50
Damascus Blade £37.50
Kitchen Blade £25
Or £100 for the lot
cheers for looking
I have a couple of forged smiths knives going. One is a skinner type. Both are made from spring steel
the skinner has a hamon
Both £25
______________________________________________________________________
HI
I made and sold one of these recently so here is another.
Made from 3.4mm thick 1080 steel, scandi ground blade with Bocote with 6mm aluminum pins and lanyard hole 167mm total (just over 6.5inch) 3.5inch handle and very comfy to use its a nice little back up knife.
Same as this but diffrent wood and crappy photos :huh:
£45
_____________________________________________________________________
Here is a few stocking filers that wont break the bank
2 little keyring fobs, hand forged from floor brads with a 15mm split ring.
£5 each inc p+p
_____________________________________________________________________
Hi
been forging a bit recently and did some digging around and finished some blades I started a while back.
3 blades all done by me.
From the top down
a bowie blade (if thats what you call it) its a forged rustic looking thing but a real chopper. Made from 1095 spring steel with a deep edge quench. 285 mm long with a 170mm blade with a sabre grind. 33mm wide and about3.2mm wide.
Next up a Alabama damascus knife. 270mm long with a 141mm bade 24mm wide and 3mm thick. Saber ground. The tang will need reducing a little at the sides.
Last one is a forged kitchen knife blade, made from spring steel it is 216mm long with a 127mm blade, 30 mm wide and 3mm thick.
Bowie blade £37.50
Damascus Blade £37.50
Kitchen Blade £25
Or £100 for the lot
cheers for looking