DIY Article
As I was asked to do a tutorial I thought I would give it a go, now I have not carved many of these before so I’m no expert but this is how I carve them.
I used a small piece of Ash about 3cm wide, so the detail is never going to be as good as a large carving.

The tools I have been using are cheap detail carving tools like these you can get them from Ebay I think I got these a few years ago for a pound.

dsc_2004

dsc_1966

I start off by carving out the size and shape of the face with the 6mm gouge.

dsc_2009

dsc_1967

When I am happy with the face size I remove the bark leaving the nose in bark.

dsc_1968

I leave the bark on the nose as a guide, you can use pencil to mark out your face details if you want or you can just do the whole carving by eye. For the next bit I use a pen or pencil to mark out details of the eye sockets and the moustache.

dsc_1969
Here you can see where the top of the eye sockets are and the shape of the moustache marked out in pencil.
Now I start to carve out the eye sockets using the 6mm gouge, to determine the depth of the eye sockets you have to imagine how big your spirits nose will be.
dsc_2009-1
dsc_1970
When your happy with the eye sockets.

dsc_1971

You can then remove any wood around the face to give the moustache, beard, and nose the shape and depth you want.
To remove the bark from the beard I use the 7mm straight bevel.
dsc_2008

Now at this stage when your happy with with your spirits face and beard you can start to add detail, I use the v shaped tool to carve out an outline around the beard

dsc_1972

dsc_2006
dsc_1973
As this is only a small simple carving I am not too bothered with the eye detail so I use a 4mm gouge tho carve out the eyes
dsc_1975
Now you can start of by adding the hair, eye brows and other details to your wood spirit.

dsc_1977
dsc_1976
dsc_1978

dsc_1979
Now that its taking shape you can refine any other details or re shape any part of the face if your not happy with it.
dsc_1996

At this stage I am quite happy with it and have an idea as to what this little spirit will become, so I start to carve the top and bottom of the spirit with the knife.
dsc_2003
dsc_2001

dsc_2013

The idea I had for this little fellow now I’m happy with him was to soak him in scented oil add some elastic.
dsc_2024
And turn him into a air freshner for the van at work, now he can watch over me all day.
dsc_2023