So I managed to finish off the dot and ring tool today. Small piece of tool/lathe CNC steel from the bay, thin cutting disc on dremel, never worried too much about over heating as just go slow. Just don't push too hard as the cutting disc may (will) pop off!
Drilled out the pith, chapped in dowel with araldite. Set up the base cover and the top. All sanded down and buffed on polisher. Top and bottom wood are both the same piece but bottom is much darker for some reason. Can you guess the wood? Thanks for looking.
Drilled out the pith, chapped in dowel with araldite. Set up the base cover and the top. All sanded down and buffed on polisher. Top and bottom wood are both the same piece but bottom is much darker for some reason. Can you guess the wood? Thanks for looking.