Recent content by Nektarios

Thanks for the comments guys, i'm glad you like it.

Thank you.

Tanto slip joint. The materials used for this one are 3.2mm RWL-34 steel for the bolsters, blade and back spring, stainless liners and red G10. Hope you like it.

Thanks for the comments much appreciated.

The materials for this one are. Orange G10 scales, stainless liners, and 3.2mm Rwl-34 for the blade and back spring. The total length in open position is: 17cm in close position it’s 9.8cm with 6.5cm cutting edge. Thanks for looking NP

Finally, it is ready to go to the new owner. I hope you like it. Thanks for looking NP

Finally, i got the time to work a bit with this folder, now it is starting to look like a knife. I hope you like it so far.

It has been long time that I dint post some of my work here, but summer time in the calendar says holydays:) However, here we go with a project I am working on now. The materials for this one are thunderstorm Kevlar scales and carbon fiber for bolsters, stainless liners and RWL 34 for the...

Thanks for the comments gents, reedx the thunderstorm Kevlarit is very nice material to Work with, and it is available only on Alpha knife suppliesin the USA.

Thanks for the comment.

Thank you.

I like to show you my second slip joint The materials for the handle are thunderstorm Kevlar scales and stainless liners. RWL-34 for the blade and back spring. The total length in open position is 18cm and 10.5cm in the close position, with 6.5cm cutting edge. I hope you like it. Thanks for...

Thank you.

Thanks allot fo the comments Guys i'm glad that you like it.

Thanks for the kind words and comments gents much appreciated. NP