Search results

Right you are Nomad64. The scientific name of the red squirrel here is Tamiasciurus hudsonicus, a different animal again. I learns something new every day. But I forget it the next:) .

Interesting read about the virus grey squirrels pass to red squirrels. Here, across the pond in Ontario I look out the window at the bird/squirrel/deer feeders and see red, grey and black squirrels together fighting over food. It is not uncommon to see the red squirrels put the run on the grey...

Thank you. This is a very helpful video. Thanks for the measurements

Over here where I am on the Colonial side of the pond we are back into winter. The weather forecasters only caught it 12 hours before hand and still got it wrong with the extent of area hit. Much bigger than they thought. Some roads are closed due to visibility and car accidents.

Yes, for Close Quarter Battle (CQB) competitions on military ranges.

Muzzle Brake for the AR15.

Probably not permitted where you are but knocking a hole in their dam usually brings them out. I've seen the top part of a dam pulled apart by hand, ( also with dynamite, but that was in kinder, gentler times), thus allowing the water to flow over the top. They seem to sense a breach in the...

I usually wear camo or olive drab in the bush and I'll wear it going to work sometimes. I normally wear it at shooting competitions too. Most of my camo I have sewn myself. The shirts are the British 95 pattern. I pulled one apart and made a pattern. I have them in olive, Marpat, OAR2...

Thanks crosslandkelly. That spacing is 30mm off from what I was able to reverse engineer from pictures on the internet. I'm thinking making the triangles 1 metre at the base by 2 metres base straight to top point. That should give some more room and simpler dimensions to work with. I have nylon...

I'm looking at making my own version of the Polish lavvu from Nylon. For those who have a Polish Lavvu, I'm wondering what the measurement is between the grommets that the pegs go through, grommet to grommet? What would be the measurement along the side with the buttons from apex to bottom? I...