Well, I had a good haul of nails at the car boot, -copper ones.
The first lot are 5mm thick; easy to find washers online.
But the second are roofing ones, round heads and square cross sections.
I probably will have to make washers; I have some lengths of old pipe.
But how would I cut them out?
And when I put them in, do the washers go on the right side of the work, or the back?
The first lot are 5mm thick; easy to find washers online.
But the second are roofing ones, round heads and square cross sections.
I probably will have to make washers; I have some lengths of old pipe.
But how would I cut them out?
And when I put them in, do the washers go on the right side of the work, or the back?