Recent content by a6cjn

Veg tanned leather is a good start and I think you should then get: A stanley knife with a new blade A pair of engineer's dividers - for marking the position of the stitch holes and can be used for creating a groove for your stitching. Some impact adhesive Waxed thread and two needles. If...

I was close, I found 'peg' which took me to 19 but I didn't see drybag :( Good comp though, might pinch the idea for another forum:thankyou: Chris:)

Thank goodness that's finished :D Thanks for a bit of fun and congrats to the winner Chris:)

Nearly all the knives shown in my sig line slideshow were done on one Chris :)

John is well known on both BB and UKB for this model he does ''50 x 686 belts from 60g-600g & can do mixed grit orders of ten belts for £13 carriage paid'' You can also do a mod on this sander by moving the belt to vertical and adding a decent table Apologies to those who are fed up of...

This chart, (from another forum) might help Hope it does Chris :)

Took me awhile to get here :rolleyes: and I see a few familiar names so I'm sure I'll find out a lot of information and it will be enjoyable as well. Chris :)